Wi-Fi Routers, Smart Meters, Cell Phone, Antennas & Cell Tower EMF Safety Missing Critical Data

CODES GOVERNING HUMAN EXPOSURE TO RADIO FREQUENCY EMFs

Health Canada’s Safety Code 6 governs human exposure to cell phones, Wi-Fi and smart meter frequencies. Safety Code 6, Page 9, paragraph 3 & 4 states “the predominant health effect to be avoided is the unintentional stimulation of tissue as is the heat effect“. Intentional stimulation of tissue is an X-ray or medical imaging in a controlled environment, an intended position of use with other parts of your body protected from frequency exposure with protective clothing.

Safety Code 6 uses the same science standards as the FCC and other international bodies. Even though science standards are based on decades of scientific literature, Safety Code 6 admits mechanisms are missing linking these frequencies to adverse health effects. Those mechanisms have been found and reported to Health Canada as well as by expert witness at the request of Canadian Parliament’s Standing Committee on Health, explanation as follows.

SPECIFIC ABSORPTION RATE(SAR)

When it comes to safety of wireless devices like cell phones, Wi-Fi and Smart Meters the Specific Absorption Rate(SAR) was adopted by Health Canada’s Safety Code 6, FCC and all international bodies. Here is a link to the test used in the Specific Absorption Rate(SAR). followed by a picture of the extremely limited test model used for exposure to wireless frequencies.

SPECIFIC ABSORPTION RATE TEST MODEL PICTURE

Liquid simulating tissue is poured in the opening at the top of the head and the white arrow is the temperature probe placed in the model to measure any temperature increases with phone use. The highest power density is measured at the base of the antenna, the red arrow shows where they measure to a localized area of the skull thought to be radiated. In order for the frequencies to hurt people, they have to hit them in other areas than a small localized area of the skull. Look at the picture of the model used and what do you see missing in the frequencies hitting people? The test model considered the phone as the end use device and left out the cell towers that complete the wireless circuit or the fact the tower frequencies would hit people from head to toe. If you look at Safety Code 6 or science standards, people were treated as heating tissue and biological electrical properties, billions of frequencies as well as vulnerability were left out of the equation. Add the missed mechanisms and it qualifies adverse health effects as well as reporting on biological effects.

Wi-Fi FREQUENCIES

When it comes to Wi-Fi safety, the wireless computer isn’t held against the head like a cell phone so Health Canada’s Data determined that everyone including classrooms of children, teachers, babies, pregnant women, pacemaker recipients can be exposed continuously 24 hours a day, 7 days a week. Dr. Tony Muc used the stove element analogy for Wi-Fi safety in Simcoe County Schools by saying, think of the computer as an element on the stove and distance keeps the children from being burned. Here is a picture of unknown origin showing Wi-Fi in schools, what do you see missing in the Wi-Fi radiation analogy?

PICTURE OF CLASSROOM WITH WIRELESS COMPUTERS


They left out the Wi-Fi Routers covering the entire room so computers or IPads can go online and the vulnerable children as well as teachers are in the circuit except unprotected from the EMF radiation. We generate electricity by moving conductors through an electromagnetic field. In this case the routers are providing the EMF and the children’s many biological considerations are the conductors. The problem is human biology already have their own electricity and frequencies. That was left out of the equation in the SAR test and it crashes the human electrical grid like our 60 Hz electrical grid would crash with foreign frequencies mixing. Go to the bottom of this page and see expert witnesses declaration taken under threat of perjury for a Wi-Fi Case in US Courts. The mechanisms reported by Curtis Bennett as a science professional qualify the biological reporting of adverse health effects by the other experts. Wi-Fi frequencies are illegal as applied, violate Safety Code 6 by stimulating and heating tissue. The present reporting using non thermal and thermal effects is ridiculous science limited by the SAR model testing seen above. Wi-Fi Health Risk Advisory

WIRELESS SMART METERS

Smart Meters are not held against the head and distance from the meter is thought to keep RF energy absorption to a minimum. Health Canada has determined RF energy from Smart Meters doesn’t pose a health risk. Here is a picture of electrical meters, one is analogue and the other is a wireless smart meter. Distance from the wireless meter is thought to make you safe, can you see what was left out of the equation on wireless danger?

ANALOGUE & WIRELESS SMART METER PICTURE

Wireless smart meters are the end use device, in order for them to work they have to connect with relays, smart meter routers, collectors, antennas, towers or the rest of the wireless network. The wireless access network wasn’t considered in the safety sheet by the utilities. The Texas Public Utilities Commission reports in their safety sheet a short distance from the meter limits exposure, Oncor utility in Texas reported smart meter routers cover an average of 5 sq. miles, the collectors 125 sq. miles so 10 feet from the meter isn’t reducing exposure. Everything in the 125 sq. miles is exposed to the frequencies. Everything living, buildings and infrastructure will be radiated by high speed frequencies. For everything living it creates a biological killing field with the frequency incompatibility.

BC Hydro reports in their fact sheet short distances from the meter limit exposure and the meter base reflects the frequencies away from the residence. They left out their relays, routers and towers, here is their grid diagram.

UTILITY WIRELESS SMART METER GRID PICTURE
UTILITY GOVERNED BY SAFETY CODE 6 ON HUMAN EXPOSURE

The diagram qualifies everything is in the circuit and violates Safety Code 6. Here is BC Hydro’s Fact Sheet and the highlighted area of Page 2 states exposure is governed by Safety Code 6 plus the specifications are the same as the FCC.

BC UTILITIES COMMISSION REQUIRES COMPLIANCE WITH SAFETY CODE 6 ON HUMAN EXPOSURE


BC Utilities Commission states in highlighted area of Page 19 compliance with Safety Code 6 is required..

PROVINCES, GOVERNMENTS & TOWERS MUST COMPLY WITH SAFETY CODE 6 ON HUMAN EXPOSURE


Provinces must comply with Safety Code 6, governments must comply with Safety Code 6. The Canadian Wireless Telecommunications Association Act states in the highlighted area of Page 10 Industry Canada has made compliance with Safety Code 6 mandatory and a condition of license for tower antennas.

DANGERS OF FREQUENCIES LECTURED IN MEDICAL EDUCATION FOR CE CREDITS


The dangers of the frequencies is now lectured in medical education for continuing education credits medical professionals require for licensing and no longer opinion. It is accepted medical education recognized and approved in North America. Here is press from the AmericanAcademy of Environmental Medicine on smart meter adverse health effects.


WIRELESS COVERAGE CREATES BIOLOGICAL KILLING FIELD


The area covered by wireless networks like routers, collectors cover big areas with each network. Oncor in Texas states the average area covered by their smart meter routers is 5 sq. miles and collector average coverage is 125 sq. miles. Everything in the coverage area doesn’t run at those frequencies and everything biological will be killed. That includes pollinators responsible for our food sources, bees, bugs, birds, trees, shrubs, crops, etc. The domino effect of trees dying will expose the ground to solar radiation and generate heat close to boiling temperature which will kill fish spawning. Here is a video of smart meter frequencies killing shrubs. When the foliage or ground cover dies, the exposed ground or buildings will be radiated by solar EMFs and generate extreme heat buildings aren’t designed for. Fish are temperature sensitive and will die as a result including the ecosystem associated with spawning. Here is a time-lapsed infrared video showing how exposed areas change temperature in minutes as well as shade effect stopping the heat.

TESTIMONY FOR TEXAS SENATE COMMITTEE ON SMART METER DANGERS


Here is a document submitted to the Lieutenant Governor of Texas and Senate Committee on the dangers of smart meters.

SMART METER FREQUENCIES RADIATING BUILDINGS


Smart meter relays, routers, cell tower antennas and the wireless access network covering large areas are radiating buildings, industry, infrastructure, etc. High speed frequencies going through walls cause vibrations of structural components and fire separations billions of times per second. That causes buildings to violate building code, here is an Open Letter to Municipalities. Industry and volatile areas are at risk with static charges developed over large areas waiting to discharge causing explosions or fires.



SMART METERS NOT ADDRESSING MASSIVE ENERGY WASTE

Buildings use energy for heating and cooling, they are designed to be energy efficient but signed off as compliant with building codes because it couldn’t be seen. Observe in the infrared spectrum how buildings are wasting fossil fuels, energy waste, electrical waste, more GHG emissions and smart meters are not addressing or recognizing the waste. Here is a link to Heat Loss Imaging in the Infrared Spectrum.

Los Angeles alone spends a reported 100 million dollars a year in energy costs responding to urban heat islands, almost 100% of it is wasted energy production reacting to symptoms. Urban Heat Islands are thought to be warmer urban areas because we couldn’t see the heat. The same solar radiation that burns skin is burning buildings and causing them to generate extreme heat they aren’t designed or insulated for. Air conditioning is in fact refrigeration and requires 1000s of watts/per hour per building of wasted electrical generation. That wastes non renewable resources, produces more GHG emissions, acid rain and superheats the atmosphere changing weather. The huge demand on power grids is one of the main reasons for smart meter implementation, unfortunately the meters aren’t catching it or addressing the waste. Alternative energy systems installed aren’t addressing the waste or the heat generated. Here is building development approaching boiling temperature.

Here is a link to infrared imaging showing buildings close to boiling temperature, heat transferring inside the building and air conditioning(refrigeration) laying on the floor while the interior is still heated. That creates an indoor weather system, compromises fire integrity, mold and the video shows an inflamed lung from indoor air quality. Think of the thermal load required to heat framing members.

Here is a link to two time-lapsed infrared videos showing natural EMFs from the sun interacting with buildings at sunrise and the second video shows how people are cooked in their buildings from the exterior being radiated. This demand creates the power outages and billions of dollars in energy waste.

SMART METER FIRES & INSTALLATION LINK

There is a big economy missed and 100s of millions of jobs available globally. This isn’t insurable and health costs, economy losses will bankrupt governments while we kill the planet that sustains all life.